Zirkonzahn M1 Soft Compatible Dental Milling Burs

Zirkonzahn M1 Soft Compatible Dental Milling Burs

Aftermarket dental milling burs cut to match OEM geometry for the Zirkonzahn M1 Soft. These burs process zirconia, PMMA, wax and metal on heavy-metal models on the Zirkonzahn M1 Soft under its native wet and dry variants per model workflow, with 3 mm shank typical so the tool changer accepts them without modification.

What's in the tool family

• Heavy roughing burs for block reduction
• Intermediate burs for contour milling
• Fine finishing burs for margin integrity and occlusal detail
• All cut to the Zirkonzahn M1 Soft tool-changer shank tolerance

When to replace

Replace burs when you start seeing fuzzy margins, white-line chipping at incisal edges, or an increase in milling time at unchanged feed and speed. All three are signs of cutting-edge wear rather than machine fault. A good habit is to photograph a fresh bur's tip under magnification and compare monthly - wear is obvious at 20x.

Before you order

Check three things on the OEM bur you are replacing: shank diameter, overall length, and tip diameter. These three specs together identify the correct aftermarket bur 95% of the time. If the spec sheet on a product page does not list what you need, contact us with the OEM part number before ordering.

Compatibility

CADBURS manufactures aftermarket dental milling burs for the Zirkonzahn M1 Soft. We are not affiliated with Zirkonzahn Srl; Zirkonzahn Srl is a trademark of its respective owner and is referenced here solely to describe machine compatibility.