IMES ICORE

IMES ICORE - 250i Compatible Dental Milling Burs

The IMES ICORE - 250i uses the standard IMES-ICORE tool-changer interface. Our burs are cut to that interface's 4 mm shank and are intended for zirconia, PMMA and wax in dry milling. They replace the OEM tool set directly without any software or collet changes.

Bur selection on the IMES ICORE - 250i

• Roughing pass: larger tip diameter for fast material removal on zirconia, PMMA and wax
• Semi-finish pass: medium diameter for axial walls
• Finish pass: small diameter for detail and margin
• Shank: 4 mm shank for direct OEM replacement

Tool life notes

Keep a simple log (job count per bur, material, any margin issues) and the pattern becomes obvious within a week or two. Most early tool failures are feed/speed or coolant issues, not bur quality - sudden chipping usually means the collet is loose or the spindle TIR has drifted, not that the bur is defective.

Support

If the first bur you order does not drop straight into the IMES ICORE - 250i tool changer, contact us with a photo of the OEM bur alongside ours and we will confirm whether it is a shank-mismatch issue or something else. We would rather get the spec right before a second order than have you run a partial batch with the wrong tool.

Compatibility

CADBURS manufactures aftermarket dental milling burs for the IMES ICORE - 250i. We are not affiliated with IMES-ICORE GmbH; IMES-ICORE GmbH is a trademark of its respective owner and is referenced here solely to describe machine compatibility.