Amann Girrbach Ceramill Matron Compatible Milling Burs

Amann Girrbach Ceramill Matron Compatible Dental Milling Burs

Aftermarket dental milling burs cut to match OEM geometry for the Amann Girrbach Ceramill Matron. These burs process zirconia, PMMA, wax and metal on Motion 3 on the Amann Girrbach Ceramill Matron under its native wet and dry per model workflow, with 3 mm shank typical on Ceramill so the tool changer accepts them without modification.

What's in the tool family

• Heavy roughing burs for block reduction
• Intermediate burs for contour milling
• Fine finishing burs for margin integrity and occlusal detail
• All cut to the Amann Girrbach Ceramill Matron tool-changer shank tolerance

When to replace

Replace burs when you start seeing fuzzy margins, white-line chipping at incisal edges, or an increase in milling time at unchanged feed and speed. All three are signs of cutting-edge wear rather than machine fault. A good habit is to photograph a fresh bur's tip under magnification and compare monthly - wear is obvious at 20x.

Before you order

Check three things on the OEM bur you are replacing: shank diameter, overall length, and tip diameter. These three specs together identify the correct aftermarket bur 95% of the time. If the spec sheet on a product page does not list what you need, contact us with the OEM part number before ordering.

Compatibility

CADBURS manufactures aftermarket dental milling burs for the Amann Girrbach Ceramill Matron. We are not affiliated with Amann Girrbach AG; Amann Girrbach AG is a trademark of its respective owner and is referenced here solely to describe machine compatibility.