Zirkonzahn M6 Teleskoper Blank Changer Compatible Dental Milling Burs

Zirkonzahn M6 Teleskoper Blank Changer Compatible Dental Milling Burs

This page covers dental milling burs that match OEM specifications for the Zirkonzahn M6 Teleskoper Blank Changer. Materials supported are zirconia, PMMA, wax and metal on heavy-metal models, run in wet and dry variants per model. Mounting uses the 3 mm shank typical so swapping from OEM burs requires no machine reconfiguration.

Bur selection on the Zirkonzahn M6 Teleskoper Blank Changer

• Roughing pass: larger tip diameter for fast material removal on zirconia, PMMA, wax and metal on heavy-metal models
• Semi-finish pass: medium diameter for axial walls
• Finish pass: small diameter for detail and margin
• Shank: 3 mm shank typical for direct OEM replacement

Tool life notes

Keep a simple log (job count per bur, material, any margin issues) and the pattern becomes obvious within a week or two. Most early tool failures are feed/speed or coolant issues, not bur quality - sudden chipping usually means the collet is loose or the spindle TIR has drifted, not that the bur is defective.

Support

If the first bur you order does not drop straight into the Zirkonzahn M6 Teleskoper Blank Changer tool changer, contact us with a photo of the OEM bur alongside ours and we will confirm whether it is a shank-mismatch issue or something else. We would rather get the spec right before a second order than have you run a partial batch with the wrong tool.

Compatibility

CADBURS manufactures aftermarket dental milling burs for the Zirkonzahn M6 Teleskoper Blank Changer. We are not affiliated with Zirkonzahn Srl; Zirkonzahn Srl is a trademark of its respective owner and is referenced here solely to describe machine compatibility.