Sirona MCX5 Compatible Milling Burs

Sirona MCX5 Compatible Dental Milling Burs

Milling burs for the Sirona MCX5, cut to the same tip geometry and shank tolerance as the OEM tool set. Used for glass ceramic, lithium disilicate, zirconia and composite blocks in the machine's standard wet milling cycle. Mounting: Sirona block-holder tool format.

What's in the tool family

• Heavy roughing burs for block reduction
• Intermediate burs for contour milling
• Fine finishing burs for margin integrity and occlusal detail
• All cut to the Sirona MCX5 tool-changer shank tolerance

When to replace

Replace burs when you start seeing fuzzy margins, white-line chipping at incisal edges, or an increase in milling time at unchanged feed and speed. All three are signs of cutting-edge wear rather than machine fault. A good habit is to photograph a fresh bur's tip under magnification and compare monthly - wear is obvious at 20x.

Before you order

Check three things on the OEM bur you are replacing: shank diameter, overall length, and tip diameter. These three specs together identify the correct aftermarket bur 95% of the time. If the spec sheet on a product page does not list what you need, contact us with the OEM part number before ordering.

Compatibility

CADBURS manufactures aftermarket dental milling burs for the Sirona MCX5. We are not affiliated with Dentsply Sirona; Dentsply Sirona is a trademark of its respective owner and is referenced here solely to describe machine compatibility.