UPCERA SMART / DGA+ Compatible Dental Milling Burs

UPCERA SMART / DGA+ Compatible Dental Milling Burs

This page covers dental milling burs that match OEM specifications for the UPCERA SMART / DGA+. Materials supported are zirconia, PMMA and wax, run in dry milling; wet on A52W / A52DW. Mounting uses the 4 mm or 6 mm depending on model so swapping from OEM burs requires no machine reconfiguration.

What's in the tool family

• Heavy roughing burs for block reduction
• Intermediate burs for contour milling
• Fine finishing burs for margin integrity and occlusal detail
• All cut to the UPCERA SMART / DGA+ tool-changer shank tolerance

When to replace

Replace burs when you start seeing fuzzy margins, white-line chipping at incisal edges, or an increase in milling time at unchanged feed and speed. All three are signs of cutting-edge wear rather than machine fault. A good habit is to photograph a fresh bur's tip under magnification and compare monthly - wear is obvious at 20x.

Before you order

Check three things on the OEM bur you are replacing: shank diameter, overall length, and tip diameter. These three specs together identify the correct aftermarket bur 95% of the time. If the spec sheet on a product page does not list what you need, contact us with the OEM part number before ordering.

Compatibility

CADBURS manufactures aftermarket dental milling burs for the UPCERA SMART / DGA+. We are not affiliated with UPCERA; UPCERA is a trademark of its respective owner and is referenced here solely to describe machine compatibility.